GSCARTSW Bumper Cases
Original price
$24.75
-
Original price
$27.50
Original price
$24.75
-
Original price
$27.50
Original price
$24.75
-
$27.50
$24.75
-
$27.50
Current price
$24.75
Earn 0.82 store credits when you buy this item
GSCARTSW Bumper Cases
Attention! There is an incompatibility with the current 5.3 GSCARTSW
This batch was produced with a new manufacturer that added an un-used connector. This connector sticks out the side of the case and blocks the case from fitting correctly. If you feel comfortable removing this connector the existing case will fit. I am working with Rondo Products to get an example of the switch with this port installed to make a new revision.
Need one of these awesome switches for your setup? Find it here: http://www.gretrostuff.com/store/
Video Install Tutorials Found below
This case allows you to use the original plexiglass panels from the GSCARTSW Case to fully enclose the switch and protect it.
Installation is simple,
Remove all the screws and spacers from your switch
Set aside your plexi panels
Press 6 of the hex spacers into the holes on the bumper case
Install the switch by putting the USB port into the hole and lever in the rest of the way
Screw the two remaining hex spacers into the center holes on the plexy top
Install the plexy top on and screw the remaining 6 screws into the top.
Flip the case over.
I insert the 8 bottom screws into the Plexy bottom and put a piece of cardboard under it to keep them in place.
put the small spacers on the screws and set the case on top of the plexy panel
Flip everything over and tighten the screws.
